Perform "Inspection After Repairs" after replacing the throttle body assembly (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
22210
1.INSTALL THROTTLE BODY ASSEMBLY
Install the No. 5 water by-pass hose to the throttle with motor body assembly, and slide the clamp to secure the hose.
| *1 | No. 5 Water By-pass Hose |
| *2 | No. 4 Water By-pass Hose |
| *a | White Mark |
Make sure the hose color is shown in the illustration.
Install the No. 4 water by-pass hose to the throttle with motor body assembly, and slide the clamp to secure the hose.
Make sure the hose color is shown in the illustration.
Align the protrusion of the gasket with the groove of the intake manifold.
| *a | Groove |
| *b | Protrusion |
| *c | Intake Manifold Side |
| *d | Throttle Body Side |
Install a new gasket to the intake manifold.
Install the throttle with motor body with the 4 bolts.
Perform "Inspection After Repairs" after replacing the throttle body assembly (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
Connect the throttle position sensor and control motor connector.
Connect the No. 5 water by-pass hose to the water inlet housing, and slide the clamp to secure the hose.
| *1 | No. 5 Water By-pass Hose |
| *2 | No. 4 Water By-pass Hose |
| *a | Yellow Mark |
| *b | Pink Mark |
Make sure the hose color is shown in the illustration.
Connect the No. 4 water by-pass hose to the No. 3 water by-pass pipe, and slide the clamp to secure the hose.
Make sure the hose color is shown in the illustration.
2.ADD ENGINE COOLANT
17880
3.INSTALL AIR CLEANER HOSE ASSEMBLY
4.INSPECT FOR ENGINE COOLANT LEAK
11209
5.INSTALL V-BANK COVER SUB-ASSEMBLY
6.PERFORM INITIALIZATION
Be sure to perform this procedure after reassembling the throttle body assembly or removing and reinstalling any throttle body component.
Perform the following procedure after replacing the ECM, throttle body assembly or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.
Be sure to perform this procedure after reconnecting the battery cable and replacing the ECM.
Disconnect the EFI NO. 1 fuse and ETCS fuse at the same time. Wait at least 60 seconds and reconnect the fuses.
Turn the ignition switch to the ON position without operating the accelerator pedal.
If the accelerator pedal is operated, perform the above steps again.
Connect the Techstream to the DLC3 and clear the DTCs (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.
| Condition | Engine Idle Speed |
|---|---|
| A/C switched off | 650 to 750 rpm |
Be sure to perform this step with all accessories off.
Make sure that the shift lever is in N or P.
Enter the following menus: Powertrain / Engine and ETC / Data List / All Data / Throttle Sensor Position. Sensor Output. Fully depress the accelerator pedal and check that the value is 60% or more.
Perform a road test and confirm that there are no abnormalities.