Home › Engine / Hybrid System › 3UR-FBE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM27M0U _51 Engine / Hybrid System _049095 3UR-FBE ENGINE CONTROL _0233938 AIR FUEL RATIO SENSOR A

3UR-FBE ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves when removing the exhaust pipe assembly.

·

The exhaust pipe assembly is extremely hot immediately after the engine has stopped.

·

Confirm that the exhaust pipe assembly has cooled down before removing it.



PROCEDURE

Hide 37117 1.REMOVE PROPELLER SHAFT HEAT INSULATOR

Hide 37140 2.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 17450B 3.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.

Disconnect the air fuel ratio sensor connector.


b.

Disconnect the heated oxygen sensor connector.


c.

Remove the 2 bolts from the center exhaust pipe assembly.


d.

Remove the 3 nuts.


e.

Disconnect the front No. 2 exhaust pipe assembly from the exhaust pipe support to remove it.


f.

Remove the 2 gaskets.


Hide 17410 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the air fuel ratio sensor connector.


b.

Detach the 2 clamps and disconnect the heated oxygen sensor connector.


c.

Remove the 2 bolts from the center exhaust pipe assembly.


d.

Remove the 3 nuts, 2 gaskets and front exhaust pipe assembly.


Hide 89467B 5.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.
A194684E02
1.99,1.073 2.615,1.073 false 2.688,0.979 3.042,1.188 0.354,0.208 10 false SST

Using SST, remove the air fuel ratio sensor.

SST
09224-00010  


Hide 89467B 6.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

a.
A194684E02
1.99,1.073 2.615,1.073 false 2.688,0.979 3.042,1.188 0.354,0.208 10 false SST

Using SST, remove the air fuel ratio sensor.

SST
09224-00010