1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
11209
4.REMOVE V-BANK COVER
17880
5.REMOVE AIR CLEANER HOSE ASSEMBLY
23280
6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
Disconnect the No. 2 fuel tube from the pressure regulator (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
Put a cloth or equivalent under the pressure regulator.
Disconnect the vacuum sensing hose from the pressure regulator.
Remove the 2 bolts and the pressure regulator.
Remove the O-ring from the pressure regulator.