1.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
55701J
2.REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY
Disconnect the washer hose and detach the 2 wire harness clamps.
Remove the 7 bolts and cowl top outer panel sub-assembly.
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
11209
5.REMOVE V-BANK COVER SUB-ASSEMBLY
Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
| *1 | V-bank Cover Grommet |
| *2 | Pin |
| *3 | No. 1 V-bank Cover Bracket |
| *4 | V-bank Cover Hook |
17880
6.REMOVE AIR CLEANER HOSE ASSEMBLY
Disconnect the vacuum hose from the air cleaner hose assembly.
Slide the clamp and disconnect the ventilation hose from the air cleaner hose assembly.
Loosen the 2 hose clamps.
Remove the air cleaner hose assembly.
12263
7.DISCONNECT VENTILATION HOSE ASSEMBLY
Slide the 2 clamps and disconnect the ventilation hose assembly from the ventilation pipe of the cylinder head cover sub-assembly and cylinder head cover sub-assembly LH.
17111
8.REMOVE INTAKE MANIFOLD
Remove the No. 1 engine cover sub-assembly.
Remove the No. 3 engine cover.
Disconnect the throttle body connector from the throttle body assembly.
Slide the 2 clamps and disconnect the 2 water by-pass hoses from the inlet water housing and front water by-pass joint.
Slide the clamp and disconnect the ventilation hose from the intake manifold.
Disconnect the 2 vacuum switching valve connectors.
Slide the clamp and disconnect the purge line hose from the purge VSV.
Remove the 2 bolts to disconnect the No. 1 tube.
Slide the clamp and disconnect the union to connector tube hose from the No. 1 tube.
Detach the 3 wire harness clamps from the 3 wire harness clamp brackets.
Remove the bolt and wire harness clamp bracket from the intake manifold.
Remove the 2 nuts, 8 bolts, intake manifold and 2 gaskets.
12264
9.REMOVE VENTILATION HOSE ASSEMBLY
Remove the 2 bolts and ventilation hose assembly from the intake manifold.
11254
10.REMOVE NO. 1 V-BANK COVER BRACKET
Remove the 2 bolts and No. 1 V-bank cover bracket.
11254B
11.REMOVE V-BANK COVER BOLT
Remove the 2 V-bank cover bolts from the intake manifold.
22030
12.REMOVE THROTTLE BODY ASSEMBLY
Remove the 4 bolts, throttle body assembly and gasket.
17650
13.REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
Disconnect the 2 vacuum hoses from the vacuum switching valve assembly.
Remove the bolt and vacuum switching valve assembly.
25860
14.REMOVE PURGE VSV
Slide the clamp and disconnect the purge line hose from the intake manifold.
Remove the bolt and purge VSV.
44774
15.REMOVE UNION TO CONNECTOR TUBE HOSE
Slide the clamp and remove the union to connector tube hose from the intake manifold.
Remove the 2 bolts and 2 wire harness clamp brackets.