77100
1.REMOVE FUEL TANK ASSEMBLY
Remove the fuel tank (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL TANK>REMOVAL).
2.REMOVE FUEL PRESSURE SWITCHING VALVE ASSEMBLY
77020A
3.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
Set SST on the retainer.
Securely attach the claws of SST to the protrusion of the retainer and fix SST in place.
Install SST while pressing the claws of SST against the retainer (towards the center of SST).
Using SST, loosen the retainer.
Do not use any tools other than those specified in this operation. Damage to the retainer or the fuel tank may result.
While pressing down on SST so that the claws of SST do not slip off the protrusion of the retainer, turn the retainer counterclockwise to loosen it.
The protrusions of the retainer fit in the ends of SST.
Remove the retainer.
Remove the fuel suction with pump and gauge tube assembly from the fuel tank.
Be careful not to bend the arm of the fuel sender gauge.
Remove the gasket from the fuel tank.
23280
4.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
83320
5.REMOVE FUEL SENDER GAUGE ASSEMBLY