77100
1.REMOVE FUEL TANK ASSEMBLY
Remove the fuel tank (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL TANK>REMOVAL).
2.REMOVE NO. 1 FUEL TUBE PROTECTOR
Remove the nut and fuel tube protector.
3.REMOVE FUEL PRESSURE SWITCHING VALVE ASSEMBLY
Disconnect the 3 fuel tank main tubes and remove the fuel pressure switching valve.
Detach the lock claws by lifting up the cover, as shown in the illustration.
Pinch and pull the fuel tank main tube connector to disconnect the main tube connector from the pipe.
Check for foreign matter in the pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the pipe and connector.
Do not use any tools to separate the pipe and connector.
Do not forcefully bend or twist the nylon tube.
Check for foreign matter on the pipe seal surface. Clean if necessary.
Put the pipe and connector ends in plastic bags to prevent damage and foreign matter contamination.
If the pipe and connector are stuck together, pinch the connector between your fingers and turn it carefully to disconnect it.