Perform "Inspection After Repairs" after replacing the fuel injector (See page Engine / Hybrid System>1UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
23250
1.INSTALL FUEL INJECTOR ASSEMBLY
Perform "Inspection After Repairs" after replacing the fuel injector (See page Engine / Hybrid System>1UR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
Attach the 3 clamps to install the No. 6 wire harness to the fuel delivery pipe sub-assembly RH.
Attach the 3 clamps to install the No. 7 wire harness to the fuel delivery pipe sub-assembly LH.
Apply gasoline or spindle oil to a new O-ring and install it to the fuel injector assembly.
Make sure that there is no damage or foreign material in the groove of the fuel injector assembly when installing the O-ring.
Connect the injector connector.
Install the fuel injector assembly to the fuel delivery pipe sub-assembly as shown in the illustration.
Make sure that there are no scratches or foreign matter in or around the insertion hole of the fuel delivery pipe sub-assembly.
When inserting the fuel injector assembly, be careful not to damage the O-ring.
Attach the part of the fuel injector labeled B between the parts of the fuel delivery pipe labeled A.
Check that each fuel injector assembly is installed to the fuel delivery pipe sub-assembly facing the direction shown in the illustration.
23808
2.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY LH
Install the 2 delivery pipe spacers and 4 insulators to the cylinder head sub-assembly LH.
Install the fuel delivery pipe sub-assembly LH (with injectors) to the cylinder head sub-assembly LH.
Install the 2 bolts.
Make sure that the part of the fuel injector labeled B is between the parts of the fuel delivery pipe labeled A.
Connect the No. 7 wire harness connector.
23807
3.INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY RH
Install the 2 delivery pipe spacers and 4 insulators to the cylinder head sub-assembly RH.
Install the fuel delivery pipe sub-assembly RH (with injectors) to the cylinder head sub-assembly RH.
Install the 2 bolts.
Make sure that the part of the fuel injector labeled B is between the parts of the fuel delivery pipe labeled A.
Connect the No. 6 wire harness connector.
23801P
4.CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
Connect the No. 1 fuel pipe sub-assembly to the fuel delivery pipe sub-assembly LH (for Quick Type B) (See page Engine / Hybrid System>1UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Attach the clamp.
23901
5.CONNECT FUEL TUBE SUB-ASSEMBLY
Connect the fuel tube sub-assembly to the fuel delivery pipe sub-assembly LH (for Quick Type A) (See page Engine / Hybrid System>1UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Connect the fuel tube sub-assembly to the fuel delivery pipe sub-assembly RH (for Quick Type A) (See page Engine / Hybrid System>1UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
23902
6.CONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY
Connect the No. 2 fuel tube sub-assembly to the fuel pressure regulator assembly (for Quick Type A) (See page Engine / Hybrid System>1UR-FE FUEL>FUEL SYSTEM>PRECAUTION).
25625
7.INSTALL EGR VALVE BRACKET
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9.CHECK FOR FUEL LEAK
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and Techstream main switch on.
Do not start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.