Home › Engine / Hybrid System › 3UR-FBE EMISSION CONTROL › AIR PUMP
RM27M0U _51 Engine / Hybrid System _049099 3UR-FBE EMISSION CONTROL _0233973 AIR PUMP A

3UR-FBE EMISSION CONTROL  AIR PUMP  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT FRONT FENDER LINER RH

(See page Vehicle Interior>EXTERIOR>FENDER LINER(for Front Side)>REMOVAL)

HINT:

It is not necessary to fully remove the front fender liner RH.

Partially remove it so that the air pump assembly with bracket can be removed in a later step.


Hide 53736 2.DISCONNECT FRONT FENDER APRON SEAL RH

a.
A153461

Using a clip remover, remove the 2 clips and fold back the fender apron seal.


Hide 17342 3.REMOVE NO. 2 AIR INJECTION SYSTEM HOSE

a.
A158592E03
0.021,0.042 3.375,0.417 3.354,0.375 10 true Engine Room Side: 0.094,2.24 0.99,3.5 0.896,1.26 10 true Front Fender RH Inside:

Engine Room Side:

i.

Disconnect the 2 clamps.


ii.

Disconnect the No. 2 hose.


iii.

Using a clip remover, remove the clamp from the body panel.



b.

Front Fender RH Inside:

i.

Disconnect the clamp.


ii.

Disconnect the No. 2 hose from the air pump.



Hide 17343 4.REMOVE NO. 3 AIR INJECTION SYSTEM HOSE

a.
A158593E04
0.094,0.063 3.396,0.542 3.302,0.479 10 true Engine Room Side: 0.125,2.292 1.01,3.333 0.885,1.042 10 true Front Fender RH Inside:

Engine Room Side:

i.

Disconnect the clamp and No. 3 hose.


ii.

Using a clip remover, remove the clamp from the body panel.



b.

Front Fender RH Inside:

i.

Disconnect the No. 3 hose from the air pump.


ii.

Using a clip remover, remove the clamp from the body panel.



Hide 5.REMOVE AIR PUMP ASSEMBLY WITH BRACKET

a.
A158597

Disconnect the 2 air pump connectors and detach the 3 wire harness claws.


b.
A158659

Remove the 2 bolts, 2 nuts and air pump.


Hide 17621A 6.REMOVE AIR PUMP INLET

a.
A273866E03
2.573,0.135 2.333,0.135 false 1.448,1.771 1.115,0.531 1.115,0.531 1.594,1.115 true 1.406,0.063 2.313,0.229 0.906,0.167 10 false Air Pump Inlet 0.188,0.146 1.042,0.625 0.854,0.479 10 false No. 1 Air Injection System Hose

Remove the 2 bolts, slide the 2 clips off of the No. 1 air injection system hoses, disconnect the hoses and remove the air pump inlet.


Hide 17341 7.REMOVE NO. 1 AIR INJECTION SYSTEM HOSE

a.

Remove the 2 No. 1 air injection system hoses.


Hide 17600C 8.REMOVE AIR PUMP ASSEMBLY

a.
A153467

Using a clip remover, detach the 2 clamps and remove the 2 air pump assemblies from the bracket.


b.

Disconnect the 6 air pump insulators.