17104
1.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY
17111
2.REMOVE INTAKE MANIFOLD
16297
3.REMOVE NO. 9 WATER BY-PASS HOSE
Slide the 2 clamps and remove the No. 9 water by-pass hose from the separator case and front water by-pass joint.
| *1 | No. 9 Water By-pass Hose |
| *2 | No. 10 Water By-pass Hose |
16293
4.REMOVE NO. 10 WATER BY-PASS HOSE
Slide the 2 clamps and remove the No. 10 water by-pass hose from the separator case and front water by-pass joint.
16261
5.REMOVE NO. 1 WATER BY-PASS HOSE
Slide the 2 clamps and remove the No. 1 water by-pass hose from the front water by-pass joint and water inlet housing.
| *1 | No. 1 Water By-pass Hose |
| *2 | No. 2 Water By-pass Hose |
16264D
6.DISCONNECT NO. 2 WATER BY-PASS HOSE
Slide the clamp and disconnect the No. 2 water by-pass hose from the front water by-pass joint.
16206
7.DISCONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY
Remove the 3 bolts and disconnect the No. 2 water by-pass pipe sub-assembly.
11212
8.REMOVE NO. 2 ENGINE COVER
77285D
9.DISCONNECT FUEL TUBE CLAMP
Disconnect the fuel tube clamp from the bracket.
12611
10.REMOVE NO. 1 ENGINE COVER
16355
11.REMOVE FRONT WATER BY-PASS JOINT
Disconnect the engine coolant temperature sensor connector.
Remove the 4 nuts, front water by-pass joint and 2 gaskets.
16279
12.REMOVE NO. 3 WATER BY-PASS PIPE
Perform this procedure only when replacement of the No. 3 water by-pass pipe is necessary.
Remove the bolt and No. 3 water by-pass pipe.
17361
13.REMOVE AIR TUBE
Slide the 2 clamps and disconnect the No. 2 air hose and No. 3 air hose.
| *1 | No. 2 Air Hose |
| *2 | No. 3 Air Hose |
Disconnect the air pump connector.
Disconnect the air pump connector clamp holder.
Using a clip remover, detach the wire harness claw.
Remove the 2 bolts and air tube.
Disconnect the 2 No. 1 air hoses from the air tube.
25710
14.REMOVE AIR SWITCHING VALVE ASSEMBLY
Disconnect the knock sensor connector.
Remove the bolt and bracket.
Disconnect the 2 air switching valve assembly connectors.
Remove the 3 bolts and air switching valve assembly.
17362
15.REMOVE NO. 2 AIR TUBE
Remove the 2 bolts, No. 2 air tube and gasket.
Be careful not to damage the installation surface of the gaskets.
17363Q
16.REMOVE NO. 3 AIR TUBE
Remove the 2 bolts, No. 3 air tube and gasket.
Be careful not to damage the installation surface of the gaskets.