Home › Engine / Hybrid System › 3UR-FE EXHAUST › EXHAUST MANIFOLD
RM27M0U _51 Engine / Hybrid System _049109 3UR-FE EXHAUST _0234046 EXHAUST MANIFOLD A

3UR-FE EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 11209 5.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 16571 8.DISCONNECT INLET RADIATOR HOSE

Hide 16572 9.DISCONNECT OUTLET RADIATOR HOSE

Hide 16361A 10.REMOVE FAN AND GENERATOR V-BELT

Hide 53736 12.REMOVE FRONT FENDER APRON SEAL RH

a.

Remove the 6 clips and fender apron seal.


Hide 53736A 13.REMOVE FRONT FENDER APRON SEAL REAR RH

a.

Remove the 5 clips and fender apron seal.


Hide 53737B 14.REMOVE FRONT FENDER APRON SEAL LH

a.

Remove the 6 clips and fender apron seal.


Hide 53739A 15.REMOVE FRONT FENDER APRON SEAL REAR LH

a.

Remove the 5 clips and fender apron seal.


Hide 11452 16.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 44320 17.DISCONNECT VANE PUMP ASSEMBLY

Hide 27020 18.REMOVE GENERATOR ASSEMBLY

Hide 88320 19.DISCONNECT COOLER COMPRESSOR ASSEMBLY

Hide 37140 20.REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)

Hide 17410 21.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 45203 22.REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY

a.
C155150E04
1.365,1.417 0.948,1.781 false 0.948,1.781 1.719,1.563 false 0.49,1.781 1.24,1.948 0.75,0.167 10 true Matchmark

Put matchmarks on the No. 2 steering intermediate shaft and steering intermediate shaft.


b.

Remove the bolt and disconnect the No. 2 steering intermediate shaft from the steering intermediate shaft.


c.
C155151E05
0.99,1.469 1.646,1.344 false 0.99,1.469 1.677,1.563 false 0.219,1.385 0.969,1.552 0.75,0.167 10 true Matchmark

Put matchmarks on the No. 2 steering intermediate shaft and the power steering gear.


d.

Remove the bolt and disconnect the No. 2 steering intermediate shaft from the power steering gear.


Hide 17168 23.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.
A162114

Remove the 3 bolts and heat insulator.


Hide 17105 24.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

a.
A162115

Remove the 10 nuts, exhaust manifold and 2 gaskets.


Hide 17167 25.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A162752

Remove the 3 bolts and heat insulator.


Hide 17104 26.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

a.
A162754

Remove the 10 nuts, exhaust manifold and 2 gaskets.