1.DISCONNECT FRONT FENDER LINER RH
(See page Vehicle Interior>EXTERIOR>FENDER LINER(for Front Side)>REMOVAL)
It is not necessary to fully remove the front fender liner RH.
Partially remove it so that the air pump assembly with bracket can be removed in a later step.
53736
2.DISCONNECT FRONT FENDER APRON SEAL RH
Using a clip remover, remove the 2 clips and fold back the front fender apron seal RH.
17342
3.REMOVE NO. 2 AIR INJECTION SYSTEM HOSE
Engine Room Side:
| *a | Engine Room Side |
| *b | Front Fender RH Inside |
Detach the 2 clamps.
Slide the clamp indicated by the arrow in the illustration and disconnect the No. 2 air injection system hose from the air tube.
Front Fender RH Inside:
Slide the clamp and disconnect the No. 2 air injection system hose from the air pump assembly.
17343
4.REMOVE NO. 3 AIR INJECTION SYSTEM HOSE
Engine Room Side:
| *a | Engine Room Side |
| *b | Front Fender RH Inside |
Detach the clamp.
Slide the clamp indicated by the arrow in the illustration and disconnect the No. 3 air injection system hose from the air tube.
Front Fender RH Inside:
Detach the clamp.
Slide the clamp indicated by the arrow in the illustration and disconnect the No. 3 air injection system hose from the air pump assembly.
5.REMOVE AIR PUMP ASSEMBLY WITH BRACKET
Disconnect the 2 air pump connectors and detach the 3 wire harness claws.
Remove the 2 bolts, 2 nuts and air pump assembly with bracket.
17621A
6.REMOVE AIR PUMP INLET
Remove the 2 bolts, slide the 2 clamps off of the No. 1 air injection system hoses, disconnect the No. 1 air injection system hoses from the air pump inlet.
| *1 | No. 1 Air Injection System Hose |
| *2 | Air Pump Inlet |
17341
7.REMOVE NO. 1 AIR INJECTION SYSTEM HOSE
Remove the 2 No. 1 air injection system hoses from the 2 air pump assemblies.
17600C
8.REMOVE AIR PUMP ASSEMBLY
Using a clip remover, detach the 2 wire harness clamps and remove the 2 air pump assemblies from the air pump bracket.
Disconnect the 6 air pump insulators.