17105
1.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
Remove the exhaust manifold LH (See page Engine / Hybrid System>3UR-FBE EXHAUST>EXHAUST MANIFOLD>REMOVAL).
2.REMOVE CAMSHAFTS (for Bank 1)
Remove the camshafts (See page Engine / Hybrid System>3UR-FBE ENGINE MECHANICAL>CAMSHAFT(for Bank 1)>REMOVAL).
13801
3.REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
Remove the 16 valve rocker arms from the cylinder head.
Arrange the removed parts in the correct order.
13750
4.REMOVE VALVE LASH ADJUSTER ASSEMBLY
Remove the 16 valve lash adjusters from the cylinder head.
Arrange the removed parts in the correct order.
13716
5.REMOVE VALVE STEM CAP
Remove the 16 valve stem caps from the cylinder head.
Arrange the removed parts in the correct order.
11101
6.REMOVE CYLINDER HEAD SUB-ASSEMBLY LH
Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.
Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.
Be sure to arrange the removed parts for each installation position separately.
Be careful not to drop washers into the cylinder head.
Head warpage or cracking could result from removing bolts in an incorrect order.
11116
7.REMOVE CYLINDER HEAD GASKET LH