1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
11209
5.REMOVE V-BANK COVER SUB-ASSEMBLY
17880
6.REMOVE AIR CLEANER HOSE ASSEMBLY
7.REMOVE AIR CLEANER ASSEMBLY
16571
8.DISCONNECT INLET RADIATOR HOSE
16572
9.DISCONNECT OUTLET RADIATOR HOSE
16361A
10.REMOVE FAN AND GENERATOR V-BELT
16711
11.REMOVE FAN SHROUD
53736
12.REMOVE FRONT FENDER APRON SEAL RH
Remove the 6 clips and fender apron seal.
53736A
13.REMOVE FRONT FENDER APRON SEAL REAR RH
Remove the 5 clips and fender apron seal.
53737B
14.REMOVE FRONT FENDER APRON SEAL LH
Remove the 6 clips and fender apron seal.
53739A
15.REMOVE FRONT FENDER APRON SEAL REAR LH
Remove the 5 clips and fender apron seal.
11452
16.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
44320
17.DISCONNECT VANE PUMP ASSEMBLY
27020
18.REMOVE GENERATOR ASSEMBLY
88320
19.DISCONNECT COOLER COMPRESSOR ASSEMBLY
37140
20.REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)
17410
21.REMOVE FRONT EXHAUST PIPE ASSEMBLY
45203
22.REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Put matchmarks on the No. 2 steering intermediate shaft and steering intermediate shaft.
Remove the bolt and disconnect the No. 2 steering intermediate shaft from the steering intermediate shaft.
Put matchmarks on the No. 2 steering intermediate shaft and the power steering gear.
Remove the bolt and disconnect the No. 2 steering intermediate shaft from the power steering gear.
17168
23.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and heat insulator.
17105
24.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
Remove the 10 nuts, exhaust manifold and 2 gaskets.
17167
25.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and heat insulator.
17104
26.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
Remove the 10 nuts, exhaust manifold and 2 gaskets.