1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
35000
3.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
for 2WD:
Refer to the following procedures (see page Drivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION ASSEMBLY>REMOVAL).
for 4WD:
Refer to the following procedures (see page Drivetrain>AB60F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION ASSEMBLY>REMOVAL).
32101
4.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
11381A
5.REMOVE REAR CRANKSHAFT OIL SEAL
Using a knife, cut off the lip of the oil seal.
Using a screwdriver, pry out the oil seal.
Do not damage the surface of the oil seal press fit hole and crankshaft.
Tape the screwdriver tip before use.