If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.
51441
1.REMOVE NO. 1 ENGINE UNDER COVER
2.DRAIN ENGINE COOLANT
11209
3.REMOVE V-BANK COVER SUB-ASSEMBLY
16572
4.DISCONNECT OUTLET RADIATOR HOSE
16031
5.REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT
Disconnect the No. 2 and No. 3 air hoses.
Disconnect the air pump connector.
Disconnect the air pump connector clamp's holder.
Using a clip remover, detach the wire harness clamp.
Disconnect the No. 5 water by-pass hose.
Remove the air tube bracket bolt.
Remove the 3 nuts, water inlet with thermostat and gasket.