11209
1.REMOVE V-BANK COVER SUB-ASSEMBLY
17700
2.REMOVE AIR CLEANER ASSEMBLY
Detach the clamp and disconnect the mass air flow meter connector.
| *A | for Type A |
| *B | for Type B |
Disconnect the ventilation hose and vacuum hose.
Loosen the hose clamp.
Remove the 2 bolts and air cleaner assembly.
19500
3.REMOVE IGNITION COIL ASSEMBLY
for Bank 1:
Detach the 3 wire harness clamps.
Disconnect the 4 ignition coil connectors.
Remove the 4 bolts and 4 ignition coil assemblies.
for Bank 2:
Detach the 2 wire harness clamps.
Disconnect the 4 ignition coil connectors.
Detach the engine wire harness clamp.
Remove the 2 bolts and disconnect the water by-pass pipe.
Remove the 4 bolts and 4 ignition coil assemblies.
19100P
4.REMOVE SPARK PLUG
Using a 16 mm plug wrench, remove the 8 spark plugs.