Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM
RM27M0U _52 Drivetrain _049120 TIRE AND WHEEL _0234088 TIRE PRESSURE WARNING SYSTEM J

TIRE AND WHEEL  TIRE PRESSURE WARNING SYSTEM  TC and CG Terminal Circuit  


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are indicated by the blinking of the tire pressure warning light.

WIRING DIAGRAM

E110507E61
5.229,4.104 6.99,4.302 1.76,0.198 10 false Tire Pressure Warning ECU 0.552,3.99 0.958,4.135 0.406,0.146 10 false DLC3 6.156,1.979 6.427,2.198 0.271,0.219 10 false TC 0.885,1.99 1.156,2.208 0.271,0.219 10 false TC 0.844,3.229 1.115,3.448 0.271,0.219 10 false CG 1.219,1.865 1.417,2.052 0.198,0.188 10 false 13 1.229,3.115 1.344,3.281 0.115,0.167 10 false 4 5.229,3.906 5.51,4.094 0.281,0.188 10 false J31 5.885,1.865 6.031,2.042 0.146,0.177 10 false 3 0.563,3.802 0.833,3.969 0.271,0.167 10 false J17

HINT:

When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.

·

It is necessary to perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or tire pressure warning valve and transmitter has been replaced.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECU AND BODY GROUND)
a.

Disconnect the J31 ECU connector.


b.
U152144E02
1.677,0.99 0.927,1.688 true 1.813,1.344 2.344,1.729 true 1.677,3.781 2.51,4.198 true 0.104,0.115 2.063,0.271 1.958,0.156 10 false Front view of DLC3: 2.406,1.688 2.635,1.844 0.229,0.156 10 false TC 0.688,1.646 0.938,1.833 0.25,0.188 10 false CG 2.573,4.125 2.823,4.292 0.25,0.167 10 false TC 0.115,2.167 2.469,2.542 2.354,0.375 10 false Front view of wire harness connector: (to Tire Pressure Warning ECU) 0.385,1.104 0.635,1.281 0.25,0.177 10 false J17 0.615,3.583 0.938,3.771 0.323,0.188 10 false J31

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
J31-3 (TC) - J17-13 (TC) Always Below 1 Ω
J31-3 (TC) - Body ground Always 10 kΩ or higher
J17-4 (CG) - Body ground Always Below 1 Ω




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR