Initialization is necessary if one of the following occurs: 1) the ECU is replaced; 2) the tire pressure warning valve and transmitter is replaced; 3) tires with a different tire standard pressure are installed; 4) the tires are rotated; or 5) a new vehicle is delivered.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C2177/77 | When all conditions below are met:
·
During initialization ·
Signal is not received from tire pressure warning valve and transmitter for 20 minutes or more ·
Vehicle speed is more than 8 km/h (5 mph) for a total of 20 minutes |
·
Tire pressure warning valve and transmitter ·
Tire pressure warning antenna and receiver ·
Tire pressure warning ECU ·
Harness or connector |
When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or valve and transmitter has been replaced.
Check if the vehicle is in conditions such as the ones described below:
Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.
If the vehicle is located in areas described above, the tire pressure warning light may blink for a minute and turn on in a particular area.
Devices using similar radio frequencies are used in the vehicle.
Facilities, or devices that use similar radio frequencies are not located in the vicinity of the vehicle.
Radio frequency may be interrupted due to surroundings or devices installed by the user.
OK
NG
Perform initialization (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION).
NEXT
A
B