Home › Drivetrain › TIRE AND WHEEL › TIRE AND WHEEL SYSTEM
RM27M0U _52 Drivetrain _049120 TIRE AND WHEEL _0234092 TIRE AND WHEEL SYSTEM G

TIRE AND WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRE

a.

Check the tires for wear and proper inflation pressure.

Standard cold tire inflation pressure:
Tire size Front
kPa (kgf/cm2, psi)
Rear
kPa (kgf/cm2, psi)
P255/70R18 210 (2.1, 30) 230 (2.3, 33)
P275/65R18
P275/55R20
P255/70R18 (Spare Tire)
P275/65R18 (Spare Tire)
230 (2.3, 33)


b.
R003031

Using a dial indicator, check the tire runout.

Tire runout:

3.0 mm (0.118 in.) or less



Hide 2.ROTATE TIRE

a.
C258067E01
0.544,0.655 0.759,0.844 0.215,0.189 10 *a

Rotate the tires as shown in the illustration.

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)

Text in Illustration
*a Front of the Vehicle


Hide 3.INSPECT WHEEL BALANCE

a.
C295016

for Steel Wheel Type:

Check and adjust the off-the-car balance.

Standard Imbalance After Adjustment:

8.0 g (0.0180 lb) or less


NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be attached.

·

Do not touch the adhesive surface of the tape.

·

Attach a sticking-type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight firmly so that it securely adheres to the position.

·

Do not reuse the balance weight.



HINT:
·

For chrome type wheels, the inner side balance weight should be installed by clipping it to the rim.

·

If necessary, check and adjust the on-the-car balance.




b.
C295017E02
0.573,3.469 0.802,3.656 0.229,0.188 10 false (A) 2.073,3.625 2.302,3.813 0.229,0.188 10 false (A)

for Aluminum Wheel Type:

Check and adjust the off-the-car balance.

Standard Imbalance After Adjustment:

8.0 g (0.0180 lb) or less


NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the sticking surface of the tape.

·

Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight firmly to adhere it to the position.

·

Do not reuse the balance weight.



HINT:

If necessary, check and adjust the on-the-car balance.



Hide 4.INSPECT FRONT AXLE HUB

Hide 5.INSPECT REAR AXLE SHAFT