Home › Drivetrain › AXLE › FRONT AXLE HUB
RM27M0U _52 Drivetrain _049151 AXLE _0234389 FRONT AXLE HUB G

AXLE  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

Hide 43512 3.REMOVE FRONT DISC

Hide 43514C 4.REMOVE FRONT AXLE HUB GREASE CAP LH (for 4WD)

Hide 5.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C159305

Using a dial indicator, measure the looseness near the center of the axle hub.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:

Ensure that the dial indicator is set at a right angle to the measurement surface.


If the looseness exceeds the maximum, replace the axle hub.


Hide 6.INSPECT FRONT AXLE HUB RUNOUT

a.
C160117

Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.

Maximum runout:

0.03 mm (0.00118 in.)


NOTICE:

Ensure that the dial indicator is set at a right angle to the measurement surface.


If the runout exceeds the maximum, replace the axle hub.


Hide 43514C 7.INSTALL FRONT AXLE HUB GREASE CAP LH (for 4WD)

Hide 43512 8.INSTALL FRONT DISC

Hide 9.CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

Hide 10.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)