Home › Engine / Hybrid System › DIFFERENTIAL › AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR(for 4WD)
RM27M0U _51 Engine / Hybrid System _049121 DIFFERENTIAL _0234100 AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR(for 4WD) A

DIFFERENTIAL  AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR(for 4WD)  INSTALLATION  


PROCEDURE

Hide 41400 2.INSTALL DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY

a.
C159278E04
1.646,1.448 1.885,1.844 1.885,1.844 1.729,1.844 false 0.875,1.75 1.823,1.958 0.948,0.208 10 false Seal Packing

Remove any old FIPG material and be careful not to drop oil on the contact surfaces of the differential tube and differential vacuum actuator assembly.


b.

Clean the contact surfaces with any residual FIPG material using gasoline or alcohol.


c.

Apply seal packing to the differential tube as shown in the illustration.

Seal packing:

Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent


HINT:

Install the differential vacuum actuator assembly within 10 minutes of applying seal packing.



d.
C159797

Clean the threads of the 4 bolts and retainer bolt holes with toluene or trichloroethylene.


e.

Install the differential vacuum actuator assembly onto the differential tube.


f.

Apply adhesive to 2 to 3 threads of each bolt end.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



g.

Install the 4 bolts.

Torque:
21 N*m (210 kgf*cm, 15 ft.*lbf)


h.

Connect the actuator hose.


i.

Connect the actuator connector.