41400
1.INSPECT DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY
Inspect the A.D.D. actuator (differential vacuum actuator assembly).
Remove the A.D.D. actuator (differential vacuum actuator assembly) (See page Engine / Hybrid System>DIFFERENTIAL>AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR(for 4WD)>REMOVAL).
Check the Free to Lock switch. Connect lines via a relay as shown in the illustration, then check that the differential vacuum actuator assembly fork moves from the Free to Lock position.
Make sure to perform this inspection with the differential vacuum actuator assembly removed from the vehicle. If this inspection is performed with the differential vacuum actuator assembly installed to the vehicle, the differential vacuum actuator assembly will be damaged.
When inspecting the differential vacuum actuator assembly, make sure to operate it with the lines connected via a relay. If the lines are not connected via a relay and battery voltage is directly applied to the differential vacuum actuator assembly, the differential vacuum actuator assembly will be damaged.
When inspecting the operation described above, use the BACK P/W NO. 2 relay.
| *a | Component without harness connector
(A.D.D. Actuator (Differential Vacuum Actuator Assembly)) |
*b | Free to Lock |
| *c | BACK P/W NO. 2 Relay | - | - |
After the Free to Lock switch is complete, inspect the A.D.D. (differential vacuum actuator assembly) detection switch and limit switch.
| Tester Connection | Condition | Condition |
|---|---|---|
| 3 (ADD) - 4 (GND) | After Free to Lock switch is complete | Below 1 Ω |
| 5 (DL2) - 4 (GND) | After Free to Lock switch is complete | 100 kΩ or higher |
| 6 (DL1) - 4 (GND) | After Free to Lock switch is complete | Below 1 Ω |
Check the Lock to Free switch. Connect lines via a relay as shown in the illustration, then check that the differential vacuum actuator assembly fork moves from the Lock to Free position.
| *a | Component without harness connector
(A.D.D. Actuator (Differential Vacuum Actuator Assembly)) |
*b | Free to Lock |
| *c | BACK P/W NO. 2 Relay | - | - |
After the Lock to Free switch is complete, inspect the A.D.D. (differential vacuum actuator assembly) detection switch and limit switch.
| Tester Connection | Condition | Condition |
|---|---|---|
| 3 (ADD) - 4 (GND) | After Lock to Free switch is complete | 100 kΩ or higher |
| 5 (DL2) - 4 (GND) | After Lock to Free switch is complete | Below 1 Ω |
| 6 (DL1) - 4 (GND) | After Lock to Free switch is complete | 100 kΩ or higher |
If there is a malfunction, replace the A.D.D. actuator (differential vacuum actuator assembly) (See page Engine / Hybrid System>DIFFERENTIAL>AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR(for 4WD)>REMOVAL). If the A.D.D. actuator (differential vacuum actuator assembly) is normal, replace the 4WD control ECU (See page Drivetrain>WF1AM TRANSFER>4WD CONTROL ECU>REMOVAL).