Home › Drivetrain › WF1AM TRANSFER › 4WD CONTROL ECU
RM27M0U _52 Drivetrain _049122 WF1AM TRANSFER _0234109 4WD CONTROL ECU A

WF1AM TRANSFER  4WD CONTROL ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55045A 3.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

Hide 4.REMOVE CLEARANCE WARNING ECU WITH BRACKET

Hide 89533 5.REMOVE 4 WHEEL DRIVE CONTROL ECU

a.
C291195

Disconnect the 2 connectors.


b.

Remove the 2 bolts and 4 wheel drive control ECU.

NOTICE:
·

Be careful not to drop the 4 wheel drive control ECU.

·

Do not subject the 4 wheel drive control ECU to strong shocks.