| U0100
|
Prohibits switching to 4L or switching from 4L for all shift positions
|
CAN communication signal from ECM is received
|
| U0122
|
Prohibits all switching except from 4H to 2WD
|
CAN communication signal from skid control ECU is received
|
| U0416
|
Prohibits all switching except from 4H to 2WD
|
Wheel speed sensor malfunction signals from skid control ECU return to normal
|
| P0560
|
Maintains current 4WD mode
|
B terminal voltage becomes 9.5 V or higher (for 1 second)
|
| P17A0
|
Prohibits switching from 2WD to 4H
|
Recovers from open circuit in the A.D.D. shift motor drive circuit (for 1 second)
|
| P17A1
|
Prohibits switching from 2WD to 4H
|
Recovers from short to ground in the A.D.D. shift motor drive circuit (for 1 second)
|
| P17A2
|
Prohibits switching from 2WD to 4H
|
Recovers from short to B+ in the A.D.D. shift motor (for 1 second)
|
| P17A4
|
Prohibits switching from 2WD to 4H
|
A.D.D. actuator limit switch (2 lines) signal returns to normal (for 1 second)
|
| P17A5
|
Prohibits switching from 2WD to 4H while the vehicle is being drive
|
Recovers from open circuit in the solenoid coil drive circuit and the ignition switch turned from off to ON
|
| P17A6
|
Prohibits switching from 2WD to 4H while the vehicle is being driven
|
Recovers from short to ground in the solenoid coil drive circuit and the ignition switch is turned from off to ON
|
| P17A7
|
Prohibits switching from 2WD to 4H while the vehicle is being driven
|
Recovers from short to B+ in the solenoid coil drive circuit and the ignition switch is turned from off to ON
|
| P17A8
|
Prohibits all switching (maintains the current position)
|
Recovers from open circuit in the transfer shift motor drive circuit and the ignition switch is turned from off to ON
|
| P17A9
|
Prohibits all switching (maintains the current position)
|
Recovers from short to ground in the transfer shift motor drive circuit and the ignition switch is turned from off to ON
|
| P17AA
|
Prohibits all switching (maintains the current position)
|
Recovers from short to B+ in the transfer shift motor drive circuit and the ignition switch is turned from off to ON
|
| P17AB
|
Prohibits all switching (maintains the current position)
|
Recovers from short to ground in the transfer shift actuator limit switch and the ignition
|
| P17AC
|
Prohibits all switching (maintains the current position)
|
Transfer shift actuator limit switch signal is returns to normal and the ignition switch is turned from off to ON
|
| P2772
|
Prohibits all switching (maintains the current position)
|
4WD HIGH and LOW position signals return to normal (for 1 second)
|
| P279E
|
Prohibits all switching (maintains the current position)
|
Transfer position switch signal returns to normal (for 1 second)
|