WF1AM TRANSFER
TRANSFER SYSTEM
TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FAIL-SAFE CHART
- DIAGNOSTIC TROUBLE CODE CHART
- U0100, U0122
- U0416 1. Ignition switch ON 2. Wheel speed sensor malfunction signals from skid control ECU are received 3. 0.06...
- P279E 1. Ignition switch is ON and engine is running 2. 2-4 terminal signal is OFF (OPEN) and LO terminal signal is...
- P2772 1. Ignition switch is ON and engine is running 2. H4 terminal signal is OFF (OPEN) and L4 terminal signal is...
- P17AC 1. When the ignition switch is ON, the engine is running, and the driving mode is being switched 2. The...
- P17AB 1. Immediately after turning the ignition switch to ON and driving mode is being switched 2. Short to ground...
- P17AA 1. Ignition switch ON (when transfer shift motor is not operating) 2. Short to B+ in the transfer shift motor...
- P17A8, P17A9
- P17A7 1. Ignition switch ON (when not switching between 2WD and 4H) 2. Short to B+ in the solenoid coil drive...
- P17A5, P17A6
- P17A4 1. Ignition switch is ON and engine is running 2. Limit switch DL1 terminal is OFF (OPEN) and the DL2...
- P17A2 1. Ignition switch ON (when not switching between 2WD and 4H) 2. Short to B+ in the A.D.D. shift motor drive...
- P0560 1. The ignition switch is ON and the transfer position switch is operated 2. Open circuit or short to ground...
- P17A0, P17A1
- Shift Motor Circuit
- 4WD Control Switch Circuit