This DTC is detected if a wheel speed malfunction signal is sent from the skid control ECU.
| DTC Code | DTC Detection Condition
1.
Diagnosis Condition 2.
Malfunction Status 3.
Malfunction Time 4.
Other |
Trouble Area |
|---|---|---|
| U0416 | 1.
Ignition switch ON 2.
Wheel speed sensor malfunction signals from skid control ECU are received 3.
0.06 secs. or more (malfunction signal received 1 or more times) 4.
1 trip detection logic |
·
CAN communication system ·
Vehicle stability control system |
Clear the DTC (See page Drivetrain>WF1AM TRANSFER>TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM>DTC CHECK / CLEAR).
Check if the same DTC is output (See page Drivetrain>WF1AM TRANSFER>TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B