Home › Drivetrain › WF1AM TRANSFER › TRANSFER OIL
RM27M0U _52 Drivetrain _049122 WF1AM TRANSFER _0234106 TRANSFER OIL G

WF1AM TRANSFER  TRANSFER OIL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK TRANSFER OIL

a.
C291183

Remove the transfer case plug (filler).


b.
C083746E16
2.646,0.906 2.854,1.104 0.208,0.198 10 false *a

Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the transfer case plug (filler) hole.

If the result is not as specified, add Toyota Genuine Transfer gear oil LF 75W or equivalent.

Text in Illustration
*a 0 to 5.0 mm (0 to 0.196 in.)

Viscosity:

SAE 75W


Standard Capacity:

1.4 to 1.5 liters (1.48 to 1.58 US qts., 1.24 to 1.32 Imp. qts.)


NOTICE:
·

After changing the oil, drive the vehicle and check the oil level again.

·

Too much or too little oil will lead to transfer problems.




c.

When the oil level is too low, check for oil leaks.


d.

Wait approximately 5 minutes and check that the oil level has not changed.


e.

Install a new transfer case plug (filler).

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)