1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
28800
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
73900
3.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Remove the lower No. 1 instrument panel airbag assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>DRIVER SIDE KNEE AIRBAG ASSEMBLY>REMOVAL).
87201
4.REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY
Remove the bolt and air duct.
47264A
5.REMOVE PUSH ROD PIN
Remove the clip and push rod pin from the brake pedal lever.
84340
6.REMOVE STOP LIGHT SWITCH ASSEMBLY
Disconnect the stop light switch connector.
Remove the stop light switch (See page Vehicle Interior>LIGHTING>STOP LIGHT SWITCH>REMOVAL).
Detach the harness clip.
84340
7.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
Remove the stop light switch mounting adjuster (See page Vehicle Interior>LIGHTING>STOP LIGHT SWITCH>REMOVAL).
55106
8.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY
Remove the brake pedal return spring.
Remove the bolt from the No. 3 brake pedal bracket.
Remove the bolt, nut and No. 3 brake pedal bracket from the brake pedal support.
Remove the 4 nuts and brake pedal support.
47121
9.REMOVE BRAKE PEDAL PAD
Remove the brake pedal pad.