Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › DRIVER SIDE KNEE AIRBAG ASSEMBLY
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234220 DRIVER SIDE KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  DRIVER SIDE KNEE AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67914 3.REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)

Hide 67914 4.REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)

Hide 55046A 7.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 73900 8.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.
B225997

Remove the 4 bolts and remove the instrument panel airbag.


b.

Detach the 2 claws and disconnect the DLC3.


c.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.