Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL
RM27M0U _54 Brake _049124 PARKING BRAKE _0234125 PARKING BRAKE PEDAL A

PARKING BRAKE  PARKING BRAKE PEDAL  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 3.RELEASE PARKING BRAKE PEDAL

Hide 73900 4.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 46410 5.DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY

a.
C154230

Remove the lock nut and adjustment nut.


b.
C154232

Remove the clip.


c.
C155437

Using a screwdriver, slowly bend up the claw.

NOTICE:

Be careful not to damage the No. 1 parking brake cable or claw.



d.

Disconnect the parking brake cable from the parking brake control pedal.


Hide 46200 6.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY

a.
C154233

Disconnect the connector.


b.

Detach the wire harness clamp from the control pedal.


c.
C154234

Remove the 3 nuts and parking brake control pedal from the body.