84540
1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Install the switch to the manual valve shaft.
Temporarily install the bolt.
Install a new lock washer and the nut.
Temporarily install the control shaft lever RH.
Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
Remove the control shaft lever RH.
Align the groove with the neutral basic line.
Hold the switch in the position described above and tighten the bolt.
Using a screwdriver, bend the tabs of the lock washer.
Install the transmission control shaft lever RH with the spring washer and nut.
Connect the switch connector.
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Connect the cable with the nut.
When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the outside of the vehicle.
3.ADJUST SHIFT LEVER POSITION
Adjust the shift lever position (see page Drivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>SHIFT LEVER ASSEMBLY(for Column Shift Type)>ADJUSTMENT).
84540
4.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Inspect the switch (see page Drivetrain>AB60E AUTOMATIC TRANSMISSION / TRANSAXLE>PARK / NEUTRAL POSITION SWITCH>ON-VEHICLE INSPECTION).