Home › Drivetrain › A760F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM27M0U _52 Drivetrain _049127 A760F AUTOMATIC TRANSMISSION / TRANSAXLE _0234163 PARK / NEUTRAL POSITION SWITCH A

A760F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Install the switch to the manual valve shaft.


b.
C155872

Temporarily install the bolt.


c.
C155871E05
1.927,1.292 2.063,0.177 2.063,0.177 1.938,0.177 true 0.792,0.083 1.927,0.406 1.135,0.323 10 true New Lock Washer

Install a new lock washer and the nut.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


d.
C155869

Temporarily install the control shaft lever RH.


e.
C155873E02
1.906,0.052 2.052,0.219 0.146,0.167 10 false N 1.021,0.271 1.146,0.438 0.125,0.167 10 false P 1.573,0.292 1.719,0.458 0.146,0.167 10 false R

Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.


f.
C351960E01
1.948,0.938 1.75,0.115 1.75,0.115 2,0.115 true 1.958,1.542 0.729,1.073 0.729,1.073 0.542,1.073 true 2.052,0.042 3.26,0.208 1.208,0.167 10 false Neutral Basic Line 0.083,0.979 0.708,1.135 0.625,0.156 10 false Groove

Align the groove with the neutral basic line.


g.

Hold the switch in position and tighten the bolt.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


h.
C155870

Using a screwdriver, bend the tabs of the lock washer.


i.
C155869

Install the transmission control shaft lever RH with the spring washer and nut.

Torque:
16 N*m (160 kgf*cm, 12 ft.*lbf)


j.

Connect the switch connector.


Hide 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

C157291

a.

Connect the cable with the nut.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)

NOTICE:

When connecting the cable to the transmission control shaft lever, make sure the L bracket of the cable faces the inside of the vehicle.



Hide 84540 5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY