A760F AUTOMATIC TRANSMISSION / TRANSAXLE
AUTOMATIC TRANSMISSION SYSTEM
- PRECAUTION
- DEFINITION OF TERMS
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- ROAD TEST
- MECHANICAL SYSTEM TESTS
- HYDRAULIC TEST
- MANUAL SHIFTING TEST
- INITIALIZATION
- MONITOR DRIVE PATTERN
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECM
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART2015.08–2016.08from 2016.08
- P2757 Lock-up does not occur when driving in the lock-up range (normal driving at 80 km/h (50 mph)), or lock-up...
- P2772 Transfer indicator switch (L4) remains on while the vehicle is being driven under the following conditions...2015.08–2016.08from 2016.08
- P2742, P2743
- P2716 Open or short is detected in the shift solenoid valve SLT circuit for 1 second or more while driving (1-trip...
- P0985, P0986
- P0982, P0983
- P0979, P0980
- P0976, P0977
- P0973, P0974
- P0894, P2714
- P0781 Conditions (a) and (b), or (a) and (c) are met (2-trip detection logic): (a) When the ECM directs the...
- P0778 The ECM checks for an open or short in the shift solenoid valve SL2 circuit while driving and shifting gears...
- P0766, P0776
- P0761 S3 stuck ON malfunction*1: When the ECM directs the transmission to switch to 5th or 6th gear, the engine...
- P0756 S2 stuck ON malfunction*1: Shifting to 3rd and 5th gears is impossible. The ECM determines there is a...
- P0751 S1 stuck ON malfunction*1: The ECM determines there is a malfunction when the following conditions are both...2015.08–2016.08from 2016.08
- P0748 The ECM checks for an open or short in the shift solenoid valve SL1 circuit while driving and shifting...
- P0729 6th gear shift malfunction: The ECM determines there is a malfunction when both of the following conditions...
- P0722 All conditions are met for 5 seconds or more continuously (2-trip detection logic): (a) No signal from speed...
- P0717 All conditions are met for 5 seconds or more (1-trip detection logic): (a) Gear change is not performed. (b)...
- P0712, P0713
- P0711 Either condition is met (2-trip detection logic): (a) Certain monitor enabling conditions are met and the ATF...2015.08–2016.08from 2016.08
- P0705 One of the following conditions is met: (A) Any 2 or more of the following signals are ON simultaneously...
- P2759 Open or short is detected in the shift solenoid valve SLU circuit for 1 second or more while driving (1-trip...
- Transmission Control Switch Circuit
- Preparation
AUTOMATIC TRANSMISSION FLUID
SPEED SENSOR
TRANSMISSION WIRE
VALVE BODY ASSEMBLY
PARK / NEUTRAL POSITION SWITCH
OIL COOLER
SHIFT LEVER ASSEMBLY(for Column Shift Type)
SHIFT LEVER ASSEMBLY(for Floor Shift Type)
SHIFT LOCK SYSTEM
TRANSMISSION CONTROL CABLE(for Column Shift Type)
TRANSMISSION CONTROL CABLE(for Floor Shift Type)
AUTOMATIC TRANSMISSION ASSEMBLY
AUTOMATIC TRANSMISSION UNIT
TORQUE CONVERTER CLUTCH AND DRIVE PLATE
OIL PUMP