33503
1.INSPECT COLUMN SHIFT SHIFT LEVER SUB-ASSEMBLY
Disconnect the transmission control switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (IG) - 13 (S) | Shift lever in S, "+" or "-" | Below 1 Ω |
| 5 (SFTU) - 11 (E) | Shift lever held in "+" (Up-shift) | |
| 4 (SFTD) - 11 (E) | Shift lever held in "-" (Down-shift) | |
| 6 (IG) - 13 (S) | Shift lever not in S, "+" or "-" | 10 kΩ or higher |
| 5 (SFTU) - 11 (E) | Shift lever in S | |
| 4 (SFTD) - 11 (E) |
If the result is not as specified, replace the column shift shift lever sub-assembly.