33550
1.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
Temporarily install the transmission floor shift assembly to the body with the 4 bolts.
Fully tighten the 4 bolts in the order shown in the illustration.
Connect the clamp and 2 connectors.
Install the cable outer of the transmission control cable assembly to the shift lever retainer, and then install a new clip.
Connect the control cable end to the shift lever assembly.
| *1 | Ridged |
Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable ridged side of the cable end is facing upward.
58861C
2.INSTALL NO. 1 CONSOLE BOX DUCT (w/ Rear Air Duct)
Install the No. 1 console box duct with the 2 clips.
3.ADJUST SHIFT LEVER POSITION
4.INSPECT SHIFT LEVER POSITION
5.INSTALL CONSOLE BOX ASSEMBLY