Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
RM27M0U _55 Steering _049129 STEERING COLUMN _0234195 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM C

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  B2624  Vehicles Speed Malfunction  


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that it is connected to the network by outputting a specified signal (periodic signal) to the communication bus on a regular schedule. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the communication bus to prevent improper operation of the auto away/return function during driving.

DTC Code Detection Condition Trouble Area
B2624 When either condition below is met:
·

The auto away function is disabled with the last vehicle speed signal* of 10 km/h (6 mph) or more.

·

The vehicle speed signal is lost for 5 seconds or more and the auto away/return function is disabled.


·

CAN communication system

·

Combination meter

·

Multiplex tilt and telescopic ECU



HINT:

*: If the ignition switch is turned OFF immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check the "COMMUNICATION STOP MODE TABLE" of the CAN communication system (see page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>PRECAUTION).

Result
Tester Display Proceed to
"Meter" is displayed. A
"Meter" is not displayed. B



A

2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)

B

2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)
a.

Use the Data List to check if the speed signal is functioning properly.

Tilt & Telescopic
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Freeze Speed Info Vehicle speed data / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) Actual vehicle speed -

Result
Result Proceed to
OK or NG (Tester indication is abnormal) A
NG (Meter indication is abnormal) B

HINT:

A vehicle speed of 3 km/h (2 mph) or more may be displayed on the Techstream screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal input via the communication bus and is not a malfunction.




A

B