Home › Steering › STEERING COLUMN › MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column)
RM27M0U _55 Steering _049129 STEERING COLUMN _0234198 MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column) A

STEERING COLUMN  MULTIPLEX TILT AND TELESCOPIC ECU(for Power Tilt and Power Telescopic Steering Column)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 45286B 3.REMOVE UPPER STEERING COLUMN COVER

a.
C290075

Remove the 2 screws.

HINT:

Turn the steering wheel to the right and left as necessary to remove the 2 screws.



b.

Detach the 4 clips.


c.
C290076

Detach the claw to remove the upper steering column cover.


Hide 45287 4.REMOVE LOWER STEERING COLUMN COVER

a.
C290077

Detach the 2 claws to remove the lower steering column cover.


Hide 55046A 5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 73900 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 89227 8.REMOVE MULTIPLEX TILT AND TELESCOPIC ECU

a.
C162089

Disconnect the 2 ECU connectors.


b.

Remove the 2 screws and ECU.