Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234207 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSTALLATION  


PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY

a.
B166448

Attach the 3 claws and install the spiral cable sub-assembly with steering sensor.

NOTICE:

When replacing the spiral cable sub-assembly with a new one, remove the lock pin before installing the steering wheel.



b.

Connect the connectors to the spiral cable sub-assembly with steering sensor.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 84306 4.ADJUST SPIRAL CABLE

a.
B166449

Check that the ignition switch is OFF.


b.

Check that the battery negative (-) terminal is disconnected.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



c.

Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.

NOTICE:

Do not turn the spiral cable sub-assembly with steering sensor by the airbag wire harness.



d.
B166450

Rotate the spiral cable sub-assembly with steering sensor clockwise approximately 2.5 turns to align the marks.

NOTICE:

Do not turn the spiral cable sub-assembly with spiral sensor by the airbag wire harness.


HINT:

The spiral cable sub-assembly with steering sensor will rotate approximately 2.5 turns to both the left and right from the center.



Hide 45187 7.INSTALL LOWER NO. 3 STEERING WHEEL COVER

Hide 45186 8.INSTALL LOWER NO. 2 STEERING WHEEL COVER

Hide 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 11.CHECK SRS WARNING LIGHT