Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
81150
1.INSTALL HEADLIGHT ASSEMBLY LH
Put protective tape around the headlight assembly LH.
| *1 | Protective Tape |
Connect each connector and attach the clamp.
Attach the claw to install the headlight assembly LH.
Install the 2 screws and bolt.
53932B
2.INSTALL FRONT END PANEL LH
53101
3.INSTALL RADIATOR GRILLE SUB-ASSEMBLY
4.ADJUST HEADLIGHT AIMING