Home › Audio / Visual / Telematics › AUDIO / VIDEO › STEERING PAD SWITCH
RM27M0U _56 Audio / Visual / Telematics _049135 AUDIO / VIDEO _0234279 STEERING PAD SWITCH A

AUDIO / VIDEO  STEERING PAD SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45186 3.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 45187 4.REMOVE LOWER NO. 3 STEERING WHEEL COVER

Hide 84250A 6.REMOVE STEERING PAD SWITCH ASSEMBLY

a.
B355116

Disconnect each connector.


b.

Remove the 4 screws.


c.
B355117

Detach the 6 guides and 2 claws and remove the steering pad switch assembly.

NOTICE:

Detach the 2 guides on the upper part of the steering pad switch assembly first.