This circuit sends a microphone signal from the telephone microphone assembly to the radio and display receiver assembly.
It also supplies power from the radio and display receiver assembly to the telephone microphone assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J139-19 (MIN-) - Body ground | Always | Below 1 Ω |
| J139-18 (SGND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| J139-4 (MACC) - Body ground | Ignition switch ACC | 4.75 to 5.25 V |
| *a | Component with harness connected
(Radio and Display Receiver Assembly) |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
A
B
C
Disconnect the J139 radio and display receiver assembly connector.
Disconnect the W7 roof console box assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J139-4 (MACC) - W7-10 (ACC) | Always | Below 1 Ω |
| J139-5 (MIN+) - W7-9 (MI1+) | Always | Below 1 Ω |
| J139-19 (MIN-) - W7-8 (MIC-) | Always | Below 1 Ω |
| J139-6 (SNS2) - W7-14 (SGND) | Always | Below 1 Ω |
| J139-4 (MACC) - Body ground | Always | 10 kΩ or higher |
| J139-5 (MIN+) - Body ground | Always | 10 kΩ or higher |
| J139-19 (MIN-) - Body ground | Always | 10 kΩ or higher |
| J139-18 (SGND) - Body ground | Always | 10 kΩ or higher |
| J139-6 (SNS2) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the telephone microphone assembly with a known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL).
Check if the same problem occurs again.
Malfunction disappears.
OK
NG