1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
33504F
3.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
58805C
4.REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
58804A
5.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
55900
6.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
86140A
7.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY
Remove the 4 bolts.
Pull the radio and display receiver assembly with bracket to detach the 3 clips and 2 guides on the backside of the radio and display receiver assembly with bracket.
Disconnect each connector and remove the radio and display receiver assembly with bracket.
86842
8.REMOVE NO. 1 NAVIGATION WIRE (w/ Satellite Radio)
86211J
9.REMOVE NO. 1 RADIO RECEIVER BRACKET
| *A | w/ Satellite Radio | *B | w/o Satellite Radio |
w/ Satellite Radio:
Remove the 5 bolts and No. 1 radio receiver bracket.
w/o Satellite Radio:
Remove the 3 bolts and No. 1 radio receiver bracket.
86212C
10.REMOVE NO. 2 RADIO RECEIVER BRACKET
| *A | w/ Satellite Radio | *B | w/o Satellite Radio |
w/ Satellite Radio:
Remove the 5 bolts and No. 2 radio receiver bracket.
w/o Satellite Radio:
Remove the 3 bolts and No. 2 radio receiver bracket.
86180
11.REMOVE STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio)