These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1551 | When one of the conditions below is met:
·
"HD Radio" tuner decoder malfunction ·
"HD Radio" tuner audio output section malfunction ·
"HD Radio" tuner decoder RF/IF malfunction |
Radio and display receiver assembly |
| B15A0 | When either of the conditions below is met:
·
Bus malfunction ·
EEPROM error |
|
| B15B0 | Picture circuit (TFT unit) malfunction | |
| B15B3 | When one of the conditions below is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
|
| B15B4 | When one of the conditions below is met:
·
Mechanical communication error ·
Load/Eject malfunction ·
Read malfunction ·
Mechanical malfunction |
|
| B15B5 | When one of the conditions below is met:
·
Mechanical communication error ·
Load/Eject malfunction ·
Read malfunction ·
Mechanical malfunction |
|
| B15B7 | "Bluetooth" module malfunction |
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C