79105A
1.INSTALL REAR OUTER SEAT LEG BRACKET SUB-ASSEMBLY RH
Install rear outer seat leg bracket sub-assembly RH with the 2 bolts.
2.INSTALL REAR INNER SEAT LEG BRACKET SUB-ASSEMBLY RH
Install rear inner seat leg bracket sub-assembly RH with the 2 bolts.
79106A
3.INSTALL REAR OUTER SEAT LEG BRACKET SUB-ASSEMBLY LH
Install rear outer seat leg bracket sub-assembly LH with the 2 bolts.
79106
4.INSTALL REAR INNER SEAT LEG BRACKET SUB-ASSEMBLY LH
Install rear inner seat leg bracket sub-assembly LH with the 3 bolts.
58426K
5.INSTALL REAR FLOOR BOARD RH
Install the rear floor board RH.
58428A
6.INSTALL NO. 2 REAR FLOOR BOARD SPACER
Install the No. 2 rear floor board spacer.
58429D
7.INSTALL REAR FLOOR BOARD SPACER
Install the rear floor board spacer.
58510D
8.INSTALL FRONT FLOOR CARPET ASSEMBLY
Return the front floor carpet assembly to its original position.
Attach the 6 clamps.
Install the tool bag.
62540
9.INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY LH
62530
10.INSTALL LOWER QUARTER TRIM PANEL ASSEMBLY RH
67872
11.INSTALL REAR DOOR WEATHERSTRIP LH
67871
12.INSTALL REAR DOOR WEATHERSTRIP RH
67918B
13.INSTALL REAR DOOR SCUFF PLATE LH
67917B
14.INSTALL REAR DOOR SCUFF PLATE RH
86150
15.INSTALL NO. 1 BOX SPEAKER ASSEMBLY (w/ Woofer)
73370B
16.CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
Connect the floor anchor of the rear seat outer belt assembly LH with the bolt.
Check that the rear seat outer belt assembly LH is not twisted.
73360B
17.CONNECT REAR SEAT OUTER BELT ASSEMBLY RH
Use the same procedure described for the LH side.
73233A
18.INSTALL REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
Use the same procedure to install the rear No. 1 seat outer lap belt anchor cover on the other side.
Attach the 2 claws and install the rear No. 1 seat outer lap belt anchor cover.
19.INSTALL REAR SEAT ASSEMBLY LH
Install the rear seat assembly LH with the 4 bolts.
Be careful not to damage the vehicle body.
Pull the No. 1 reclining adjuster release handle LH and fold down the seat cushion.
73390A
20.INSTALL REAR SEAT INNER BELT ASSEMBLY
Pass the rear seat inner belt assembly through the rubber band of the separate type rear seatback cover in the direction indicated by the arrow shown in the illustration.
| *1 | Rubber Band |
| *2 | Protruding Part |
Install the rear seat inner belt assembly with the bolt.
Do not allow the anchor of the rear seat inner belt assembly to overlap the protruding part.
21.INSTALL REAR SEAT ASSEMBLY RH
Install the rear seat assembly RH with the 4 bolts.
Be careful not to damage the vehicle body.
Pull the No. 1 reclining adjuster release handle RH and fold down the seat cushion.