66102E
1.INSTALL TAIL GATE MALE HINGE SUB-ASSEMBLY LH
Using a T40 "TORX" wrench, install the tail gate lock male hinge sub-assembly with the 2 screws.
66101E
2.INSTALL TAIL GATE MALE HINGE SUB-ASSEMBLY RH
Using a T40 "TORX" wrench, install the tail gate lock male hinge sub-assembly with the 2 screws.
66120F
3.INSTALL TAIL GATE HINGE ASSEMBLY LH
Using a T40 "TORX" wrench, install the tail gate hinges to the tail gate with the 2 screws.
Install the bolt to the tail gate.
66110F
4.INSTALL TAIL GATE HINGE ASSEMBLY RH
Using a T40 "TORX" wrench, install the tail gate hinges to the tail gate with the 2 screws.
Install the bolt to the tail gate.
65700
5.INSTALL REAR BODY TAIL GATE ASSEMBLY
Move the tail gate in the direction of arrow 1 in the illustration to connect the tail gate hinge LH.
Move the tail in the direction of arrow 2 in the illustration to connect the tail gate assembly hinge RH and install the tail gate.
65770A
6.INSTALL TAIL GATE STAY ASSEMBLY
Install the tail gate cable and gate side shaft to the tail gate.
Install the tail gate cable and deck side shaft to the body.
Use the same procedures described above to the other side.
66780
7.INSTALL SIDE GATE SUPPORT SUB-ASSEMBLY LH
Install the side gate support.
Install the side gate support while supporting the body by hand.
Check that the side gate support is engaged in the ball joint and it cannot be pulled out.
81560
8.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
65768A
9.INSTALL TAIL GATE LOCK STRIKER
Using a T40 "TORX" wrench, install the 2 tail gate lock strikers with the 4 screws.
69055B
10.INSTALL TAIL GATE LOCK KEY CYLINDER
Install the tail gate lock cylinder with the snap ring.
69090B
11.INSTALL TAIL GATE HANDLE ASSEMBLY
Install the tail gate handle with the 2 bolts.
86790
12.INSTALL TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)
65797B
13.INSTALL TAIL GATE LOCK CONTROL LINK LH
Install the control rod.
65797A
14.INSTALL TAIL GATE LOCK CONTROL LINK RH
Install the control rod.
65790A
15.INSTALL TAIL GATE LOCK ASSEMBLY LH
Using a T40 "TORX" wrench, install the tail gate lock with the 2 screws.
Connect one end of the tail gate lock link to the tail gate lock and another end to the tail gate handle.
65780A
16.INSTALL TAIL GATE LOCK ASSEMBLY RH
Using a T40 "TORX" wrench, install the tail gate lock with the 2 screws.
Connect one end of the tail gate lock link to the tail gate lock and another end to the tail gate handle.
65759
17.INSTALL TAIL GATE SERVICE HOLE COVER
Using a T30 "TORX" wrench, install the service hole cover with the 8 screws.
65717A
18.INSTALL TAIL GATE PROTECTOR
86790
19. CHECK CONNECTION OF TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)