A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
65717A
1.REMOVE TAIL GATE PROTECTOR
65759
2.REMOVE TAIL GATE SERVICE HOLE COVER
Using a T30 "TORX" socket, remove the 8 screws and service hole cover.
65790A
3.REMOVE TAIL GATE LOCK ASSEMBLY LH
Remove the tail gate lock links from the tail gate lock and tail gate handle assembly.
Using a T40 "TORX" socket, remove the 2 screws and tail gate lock.
65780A
4.REMOVE TAIL GATE LOCK ASSEMBLY RH
Remove the tail gate lock links from the tail gate lock and tail gate handle assembly.
Using a T40 "TORX" socket, remove the 2 screws and tail gate lock.
65797B
5.REMOVE TAIL GATE LOCK CONTROL LINK LH
Remove the control rod.
65797A
6.REMOVE TAIL GATE LOCK CONTROL LINK RH
Remove the control rod.
86790
7.REMOVE TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)
69090B
8.REMOVE TAIL GATE HANDLE
Remove the 2 bolts and tail gate handle.
69055B
9.REMOVE TAIL GATE LOCK KEY CYLINDER
Pull off the snap ring and remove the tail gate lock key cylinder.
65768A
10.REMOVE TAIL GATE LOCK STRIKER
Using a T40 "TORX" socket, remove the 4 screws and 2 tail gate lock strikers.
81560
11.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
66780
12.REMOVE SIDE GATE SUPPORT SUB-ASSEMBLY LH
Using a screwdriver, remove the side gate support while releasing the 2 clips.
Tape the screwdriver tip before use.
65770A
13.REMOVE TAIL GATE STAY ASSEMBLY
Remove the deck side shaft and tail gate stay from the body.
Remove the gate side shaft and tail gate stay.
Use the same procedures described above for the other side.
65700
14.REMOVE REAR BODY TAIL GATE ASSEMBLY
Pull up the tail gate in the direction of arrow 1 from the tail gate hinge assembly RH slot as shown in the illustration.
Move the tail gate rearwards and then pull in the direction of arrow 2 as shown in the illustration to remove the tail gate.
66120F
15.REMOVE TAIL GATE HINGE ASSEMBLY LH
Remove the bolt.
Be careful not to drop the tail gate.
Using a T40 "TORX" socket, remove the 2 screws and tail gate hinge from the tail gate.
66110F
16.REMOVE TAIL GATE HINGE ASSEMBLY RH
Remove the bolt.
Be careful not to drop the tail gate.
Using a T40 "TORX" socket, remove the 2 screws and tail gate hinge from the tail gate.
66102E
17.REMOVE TAIL GATE MALE HINGE SUB-ASSEMBLY LH
Using a T40 "TORX" socket, remove the 2 screws and tail gate male hinge from the tail gate.
66101E
18.REMOVE TAIL GATE MALE HINGE SUB-ASSEMBLY RH
Using a T40 "TORX" socket, remove the 2 screws and tail gate male hinge from the tail gate.