Home › Vehicle Interior › ENGINE HOOD / DOOR › FRONT DOOR(for Double Cab)
RM27M0U _58 Vehicle Interior _049138 ENGINE HOOD / DOOR _0234336 FRONT DOOR(for Double Cab) N

ENGINE HOOD / DOOR  FRONT DOOR(for Double Cab)  ADJUSTMENT  


CAUTION / NOTICE / HINT

B057104E34
0.219,1.365 1.354,1.583 1.135,0.219 10 false Centering Bolt 2.146,1.469 3.208,1.698 1.063,0.229 10 false Standard Bolt

HINT:
·

Before adjusting the door position for vehicles equipped with side airbags and curtain shield airbags, be sure to disconnect the battery. After adjustment, inspect the SRS warning light and check for DTC (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).

·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.

·

Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (w/ washers) when making adjustments.

·

A bolt without a torque specification is shown in the standard bolt chart (see page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.ADJUST FRONT DOOR

a.
B166220

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:
·

Some systems need to be initialized after the cable is reconnected (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

·

After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.




b.

Using SST, loosen the body's hinge bolts and adjust the door's position.

SST
09812-00010  


c.

Using SST, tighten the body's hinge bolts after the adjustment.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


d.

Loosen the door's hinge bolts and adjust the door's position.


e.

Tighten the door's hinge bolts after the adjustment.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


f.
B166222

Adjust the striker position by slightly loosening the striker mounting screws with a T40 "TORX" socket and hitting the striker with a plastic-faced hammer.


g.

Using a T40 "TORX" socket, tighten the striker mounting screws after the adjustment.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)


h.

Connect the cable to the negative (-) battery terminal.

NOTICE:

Some systems need to be initialized after the cable is reconnected (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).