Home › Vehicle Interior › ENGINE HOOD / DOOR › FRONT DOOR(for Double Cab)
RM27M0U _58 Vehicle Interior _049138 ENGINE HOOD / DOOR _0234336 FRONT DOOR(for Double Cab) A

ENGINE HOOD / DOOR  FRONT DOOR(for Double Cab)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 69284C 3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

a.
U151896E01
1.134,1.893 1.152,1.875 1.152,1.875 1.166,1.875 false

Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

HINT:

Tape the screwdriver tip before use.



Hide 74232 4.REMOVE FRONT UPPER ARMREST BASE PANEL LH

a.
B360301

Using a moulding remover A, detach the 2 clips and 5 claws, and remove the front upper armrest base panel LH.


b.
B360303

Disconnect the master switch connector.


Hide 84820 5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

Hide 67492A 6.REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

a.
B356772

Detach the 3 clips and remove the door lower frame bracket garnish.


Hide 74222A 7.REMOVE FRONT DOOR ARMREST COVER LH

Hide 67602 8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

a.
B354846E01
2.28,0.177 2.580,0.375 0.299,0.198 10 Clip 3.254,1.547 2.698,0.269 2.698,0.269 2.63,0.269 false

Remove the 2 screws.


b.

Using a clip remover, remove the clip.


c.

Detach the 9 clips and remove the trim cover. Then disconnect the connector.


d.
B165654E02
2.667,1.625 2.688,1.938 2.688,1.938 2.177,1.938 false 2.323,0.99 2.792,0.167 2.792,0.167 2.417,0.167 false 0.979,0.073 2.615,0.354 1.635,0.281 10 false End Cap (Color: White) 0.74,1.844 2.167,2.146 1.427,0.302 10 true End Cap (Color: Green)

Disconnect the 2 cables from the inside handle.


e.

Remove the inside handle.


Hide 68172A 9.REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH

Hide 84927 10.REMOVE SEAT MEMORY SWITCH (w/ Seat Memory Switch)

a.
B166227

Remove the 2 screws and seat memory switch.


Hide 89430 11.REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY (w/ Power Mirror Control System)

a.
B166706

Disconnect the 2 ECU connectors.


b.

Remove the 2 screws and ECU.


Hide 87940 12.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 67625A 14.REMOVE FRONT NO. 1 DOOR TRIM BRACKET

a.
B165656

Remove the 2 screws and bracket.


Hide 67832 15.REMOVE FRONT DOOR SERVICE HOLE COVER LH

a.
B166952

Using a clip remover, detach the 2 clamps.


b.
B165658

Remove the front door service hole cover LH.

HINT:

Remove the remaining tape on the door.



Hide 68102 16.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

a.

for Driver Side:

i.

Temporarily install the power window regulator master switch.



b.

for Passenger Side:

i.

Temporarily install the power window regulator switch.



c.

Connect the cable to the negative (-) battery terminal.


d.
B166216

Move the door glass until the bolts appear in the service holes.


e.

Remove the 2 bolts.

NOTICE:

Be careful when removing the bolts as the glass may fall and become damaged.



f.
B166217

Remove the door glass in the direction indicated by the arrows in the illustration.

HINT:

Remove the glass upward.


NOTICE:

Be careful not to damage the glass.



g.

for Driver Side:

i.

Remove the power window regulator master switch.



h.

for Passenger Side:

i.

Remove the power window regulator switch.



i.

Disconnect the cable from the negative battery (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



Hide 69802 17.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

a.

Disconnect the connector.


b.
B166218E03
1.604,1.188 1.813,1.333 0.208,0.146 1.469,1.052 1.74,1.063 1.74,1.063 2.365,1.406 false 0.479,0.979 1.458,1.354 0.979,0.375 10 true Temporary Bolt

Loosen the temporary bolt.

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall and become damaged.



c.

Remove the 5 bolts and window regulator.


d.

Remove the window regulator through the service hole.


e.

Remove the temporary bolt from the front door window regulator.


Hide 85720A 18.REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.
B165662

Using a T25 "TORX" driver, remove the 3 screws and motor.

NOTICE:

Be careful when removing the screws as the motor may fall and become damaged.



Hide 89860A 19.REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH

a.
B166953

Disconnect the connector.


b.

Remove the bolt and side airbag sensor.


Hide 68210C 20.REMOVE FRONT OUTER DOOR GLASS WEATHERSTRIP ASSEMBLY LH

Hide 68151E 21.REMOVE FRONT DOOR GLASS RUN LH

a.
B165689

Remove the front door glass run.


Hide 67404F 22.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

a.
B165664

Remove the 2 bolts and front door rear lower frame.

HINT:

Remove the frame through the service hole.


NOTICE:

Be careful when removing the bolts as the frame may fall and become damaged.



Hide 67402F 23.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH

a.
B165663

Remove the 2 bolts and front door front lower frame.

HINT:

Remove the frame through the service hole.


NOTICE:

Be careful when removing the bolts as the frame may fall and become damaged.



Hide 69217F 24.REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH

a.
B165665E02
0.607,1.626 1.345,1.928 0.738,0.303 10 Hole Plug 2.889,1.739 1.377,1.739 false

Remove the hole plug.


b.

Using a T30 "TORX" wrench, loosen the screw and remove the front door outside handle cover and the door lock key cylinder as a unit.


c.

Remove the cylinder from the cover.


Hide 69320 25.REMOVE FRONT DOOR LOCK ASSEMBLY LH

a.
B165669

Disconnect the connector.


b.

Using a T30 "TORX" wrench, remove the 3 screws and door lock.

HINT:

Remove the door lock through the service hole.


NOTICE:

Be careful when removing the bolts as the door lock may fall and become damaged.



Hide 69720B 26.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

a.
B165670E05
2.125,1.125 2.125,1.594 false 1.458,1.625 2.979,2.052 1.521,0.427 10 true End Cap (Color: Yellow)

Remove the front door lock remote control cable assembly.


Hide 69760C 27.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

a.
B165671

Using a screwdriver, detach the 3 claws.

HINT:

Tape the screwdriver tip before use.



b.
B165672E03
2.125,0.958 2,0.167 2,0.167 1.781,0.167 false 0.406,0.083 1.771,0.521 1.365,0.438 10 true End Cap (Color: Blue)

Remove the front door inside locking cable.


Hide 69220 28.REMOVE FRONT DOOR HANDLE ASSEMBLY OUTSIDE LH

a.
B165666

Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.

NOTICE:

If the release plate is not pulled and held when removing the handle, the release plate will interfere with the handle and become damaged.



Hide 69202A 29.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH

a.

Remove the front and rear outside handle pads.


b.
B165673

Using a T30 "TORX" wrench, loosen the screw.


c.

Slide the outside handle frame to remove it.

HINT:

Remove the outside handle frame through the service hole.



Hide 69332 30.REMOVE FRONT DOOR LOCK OPEN ROD LH

a.

Remove the lock open rod from the outside handle frame.


Hide 67924 31.REMOVE FRONT NO. 2 DOOR STIFFENER CUSHION

a.
B165680

Using a clip remover, remove the 2 clips and stiffener cushion.


Hide 67856B 32.REMOVE FRONT DOOR PANEL PROTECTOR LH

a.
B166214

Using a clip remover, detach the 8 clips and remove the door panel protector.

HINT:

If clips are damaged during removal, replace them.



Hide 68620 33.REMOVE FRONT DOOR CHECK ASSEMBLY LH

a.
B165675

Remove the bolt, 2 nuts and door check.

HINT:

Remove the door check through the service hole.


NOTICE:

Be careful when removing the bolts as the door check may fall and become damaged.



Hide 67862 34.REMOVE FRONT DOOR WEATHERSTRIP LH

a.
B166219

Using a clip remover, detach the 38 clips and remove the weatherstrip.

HINT:

If clips are damaged during removal, replace them.