Before adjusting the door position for vehicles equipped with side airbags and curtain shield airbags, be sure to disconnect the battery. After adjustment, inspect the SRS warning light and check for DTC (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (w/ washers) when making adjustments.
A bolt without a torque specification is shown in the standard bolt chart (see page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.ADJUST FRONT DOOR
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Some systems need to be initialized after the cable is reconnected (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Using SST, loosen the body's hinge bolts and adjust the door's position.
Using SST, tighten the body's hinge bolts after the adjustment.
Loosen the door's hinge bolts and adjust the door's position.
Tighten the door's hinge bolts after the adjustment.
Adjust the striker position by slightly loosening the striker mounting screws with a T40 "TORX" socket and hitting the striker with a plastic-faced hammer.
Using a T40 "TORX" socket, tighten the striker mounting screws after the adjustment.
Connect the cable to the negative (-) battery terminal.
Some systems need to be initialized after the cable is reconnected (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Inspect the SRS warning light (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).