Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM27M0U _51 Engine / Hybrid System _049139 CRUISE CONTROL _0234343 CRUISE CONTROL SYSTEM D

CRUISE CONTROL  CRUISE CONTROL SYSTEM  DIAGNOSIS SYSTEM  


CHECK INDICATOR (for LCD Type)


a.

Turn the ignition switch ON.


b.
E280128E01
0.059,0 2.298,0.218 2.239,0.218 12 Cruise Control Indicator Light:

Check that the cruise control indicator light illuminates when the cruise control main switch is turned ON, and that the indicator light turns off when the main switch is turned OFF. If the results are not as specified, inspect the cruise control indicator light circuit (see page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>Cruise Main Indicator Light Circuit).

HINT:
BE04034E73
0.031,0 2.313,0.198 2.281,0.198 12 false Cruise Control Indicator Light: 0.365,0.542 1.177,0.74 0.813,0.198 10 false 1.5 seconds. 1.51,0.531 2.344,0.729 0.833,0.198 10 false 0.5 seconds. 0.146,1.063 0.427,1.26 0.281,0.198 10 false On 0.146,1.646 0.5,1.844 0.354,0.198 10 false Off

While driving with cruise control, the ECM activates AUTO CANCEL of the cruise control system when a malfunction in one of the following occurs: vehicle speed sensors, stop light switch or other related parts. When AUTO CANCEL is activated, the cruise control indicator outputs the blinking pattern shown in the illustration. At the same time, data of the malfunction is stored as a DTC.




CHECK INDICATOR (for TFT Type)


a.
E280127E01
0.696,0.079 2.088,0.255 1.392,0.177 10 Master Warning Light 0.413,2.39 2.284,2.567 1.871,0.177 10 Cruise Control Indicator Light

When a malfunction occurs in the cruise control system, the system turns off the cruise control indicator and the master warning light illuminates at the same time a "pong" sound is heard. Also, cruise control indicator light is displayed in the multi-information display and the ECM stores DTCs.

HINT:
·

If the system returns to normal, the cruise control indicator light message on the multi-information display disappears.

·

Do not remove fuses or disconnect the battery cables until the inspection is finished. Otherwise, the data stored in the ECM will be cleared.